Connect ASIair with Celestron Skyportal Wifi adaper

radinkel

Hello,

I would like to connect the Asiair to the Celestron skyportal wifi adapter (AP mode) and thus avoid the USB cable.

1. Is that possible?

2. Which settings are necessary for configuring the AP mode (e.g. DCHP yes / no, if no which IP, gateway etc.?)

3. Which settings are necessary to configure the telescope settings in asiair (IP, port, protocol)?

Thanks in advance!

Ralf

PMTeam@ZWO

radinkel wrote:

Hello,

I would like to connect the Asiair to the Celestron skyportal wifi adapter (AP mode) and thus avoid the USB cable.

1. Is that possible?

2. Which settings are necessary for configuring the AP mode (e.g. DCHP yes / no, if no which IP, gateway etc.?)

3. Which settings are necessary to configure the telescope settings in asiair (IP, port, protocol)?

Thanks in advance!

Ralf

Same like this, please have a try. https://astronomy-imaging-camera.com/manuals/ASIAIR_Sky-Watcher_AZ-GTI.pdf

yorkpf

After reading the linked page, I still cannot work out how to go about setting up ASIair to drive the mount using the Celestron Skyportal Wifi Adapter. Could you please reply, being more specific?

I am using the ASIair with a NexStar 6se (altazimuth) telescope. Is it correct to set the telescope setting to "Celestron Nexstar GPS/SLT/SE"?

Regards

Paul

PMTeam@ZWO

yorkpf wrote:

After reading the linked page, I still cannot work out how to go about setting up ASIair to drive the mount using the Celestron Skyportal Wifi Adapter. Could you please reply, being more specific?

I am using the ASIair with a NexStar 6se (altazimuth) telescope. Is it correct to set the telescope setting to "Celestron Nexstar GPS/SLT/SE"?

Regards

Paul

Hey Paul, someone made it, please try : https://www.youtube.com/watch?v=haQj-kiE5ec