Hello All,
Wondered if someone could shed some light, connected ASIAIR (plus version on 1.8 , 8.83) however this time I was powering ASIAIR using 12v Mains (not the usual 12V 50aH battery pack) and this resulted in ASI294MM pro not being detected...So I tried these things in following steps:
- At first not being detected even though the fan was running
- after pulling the power cord and USB 3 out (in succession) and reconnecting (at camera end) the camera was detected by ASIAIR but ASIAIR would not connect to it.
- Shut down and restart ASIAIR, same thing as Step 2
- Another shut down and restart but this time pulling out the USB 3 from ASIAIR and connecting to a different USB 3 port i.e. the second USB 3 port.....This time all good...
I think one of the USB 3 ports (on ASIAIR Side) must have overloaded or something, Is there a way to reset it?
I'm doing Darks today so once all done I'll try any recommendations...
Thanks in advance.
