ASIDeepstack process

generalzod

Just wondering is anyone having any issues with processing stack files, files are loaded successfully and I initiate the stack process, It starts but during the process it just shutdowns? Any suggestions.

GoKidd

Experiencing the same problem. Version 1.9.1 abends if I add calibration files to the stack.

DavesView

Same here. Very aggravating! No error code, just poof and it's gone.

DavesView

OK! Where's the support on this issue. I just took the time to load 60 subs, the associated darks, flats and bias frames. Executed stack and at 34% (it's always at the 34% mark) into processing the darks, the program crashed. It's very aggravating at first, but after posting to the forum and receiving no reply, then it happens again... it's extremely aggravating. So first we have very aggravating, then extremely aggravating. Let's not go to the next level. What is going on with the software?

RichNH

I was having a problem with the ASIDeepStack program also. The problem I was having is this: On the first load of files for all calibration files and the Lights files the DeepStack process worked. I keep my various calibration files in separate folders. I found that the first time I ran the process ASIDeepStack would create master files in each of the separate folders. These Master files would have "AutoSave" as part of the file name. On any subsequent stack process, not realizing what I was doing, I would include these master files in the selection, or perhaps I tried just using the master files. But the master files that are created do not have the BAYERPAT value filled in whereas the original fits files do. So when you try to stack more Lights using these "master" files, the BAYERPAT values do not match and the program abends (although I do note that in my case the program does display a message box indicating that some files have errors in them).