ASI 120MM (non ST4 Port version) not working with TheSkyX

robertm

Hi,

I'm trying to get my ASI 120MM working as an autoguider with TheSkyX but get an error "No response from the device. Error = 203" when taking an image (and after a short delay). I can get the camera working with MaximDL but it downloads a blank image however the camera does work with SharpCap wihout any issues. In TheSkyX I'm using the "ASI Cameras ASCOM driver" and it seems to connect to the camera ok as I get the firmware version (181596860) displayed. The ASCOM driver version is 1.60.

I would be very grateful if anyone could help.

Thanks

Robert

Sam@ZWO

Hi Robert

can you try the beta version of ASCOM driver from here?:

http://zwoptical.com/software/ASICamera%20ASCOM%20Setup%20test.exe

robertm

Hi,

I tried that and The SkyX got further. There was no error but the progress bar showing the exposure stops at around 0.04s to go and when I press abort I get a black image shown (completely black with no signal). I then have to disconnect and reconnect to try another image.

Is there anything I can do to help ?

Many thanks

Robert