There is this (I think) bug in the asiair software when using auto run.
I use the star atlas to go to a star near meridian/equator then do calibration.
After that I open the images and open one that I want to image again this night. I click goto.
After that the name in the autorun then stays on the star/object picked from the star atlas.
I think this is unintentional. Yes you can change it in the autorun but if I have an object imaged before wouldn't it make more sense if the images come in the same folder. Now for example I have 1 folder IC443 with right object, then 56 Orionis and epsilon Monoceros.
Steps to reproduce
- Pick object in star atlas and goto
- Open image management and open image from previous session
- Goto that image
- Open Autorun and check name of object
