Problem with v2.4 Auto Focus

WC0ZSm8I

With v2.4 I have a problem with the Auto Focus (AF). I started by using the Framing mode in the Alt/Az mode. After moving the target to center it in the Framing Mode FOV I used GoTo to center the telescope on the desired position. Once the telescope successfully centered on the desired position I started the AF, and, the guiding stopped!! I know it stopped because the stars started drifting across the FOV displayed on my laptop. By the time the AF was complete and the guiding started again, the FOV was no longer centered on the original position.

Am I doing something wrong, or, is this a problem?

Steve

Support@Seestar

Position changes during focus: When autofocus is in progress, focus adjustments may cause the telescope's position to change slightly, especially in Alt/Az mode, where this change is more noticeable.
Failure to realign the target: If the target position is not realigned after autofocus, the target will drift.

Recommendations:
Manual adjustment: Try to manually realign the telescope to the target position after focusing to ensure that there is no drift after focusing.
Use equatorial mode: If possible, try switching to equatorial mode for autofocus, as the tracking and alignment of the telescope in equatorial mode may help reduce this drift.
Regular calibration: Make sure to calibrate the telescope's level and position before any shooting, especially before autofocusing.