Controling the Wanderer V4-EC flat panel with the 2600MC Air

0I3H2C81

Hello,

I've been building my new rig and just purchased a 2600MC Air camera. I want to control my Wanderer V4-EC flat panel through the ASI Air app. Wanderer says this panel can now be controlled via the ASIAIR Plus which I thought would also include the 2600MC Air camera. However, when I look for the device in the ASIAIR app (version 2.4.1 (41.95) in the WiFi tab, I cannot see any way to control or identify devices connected to the 2600MC Air's DC OUT ports. The only DC port listed there is reading out data for the DC power IN values.

There are three DC ports on that camera and the manual says you can supply DC power IN to any one of them which then defaults the other two ports to DC OUT mode ONLY. I have the camera's DC power IN cable plugged into the far left side port with the middle and right side ports available. I then have the Wanderer panel power connected to the 2600 DC OUT port on the far right, but the device seems invisible to the ASIAIR app.

Is there any FIX for this or am I doing something wrong?

Thanks!

DeepSkyOne

As far as I know, the DC power ports on the MC/MM Air cameras and the ASIAIR Mini can't be software controlled in the ASIAIR App. You need an ASIAIR Plus to control the DC output ports.

CS Dani