ZWO ADC help

2barrel

Hello all. Need a little advice. The other night I was trying to image Jupiter with my ZWO ADC and ran into a small problem.

I started imaging Jupiter without a barlow and everything went smooth. Was able to adjust it darn near perfect using the Firecapture ADC tool.

The problem started when I added my 2X E.S. barlow. The only way I could get the ADC corrected was if I only adjusted 1 lever keeping the other in the neutral position. I know my ADC is a righty and it was level.

My scope is a 8 inch EdgeHD and I'm using a Asi224MC camera.

Has anybody ran into a problem like this? Could severe light pollution have an effect on a ADC causing something like this to happen ?

P.S.

I did post this question on another forum and thought I'd post it here for further assistance.

Sam@ZWO

actually, 2X barlow added should easy to adjust ADC than without barlow

2barrel

That's what I thought too Sam.

I'm stumped :?:

2barrel

Also I did wind up getting it to work with the barlow. But it was by only adjusting one lever and keeping the other in the neutral position.

Support@ZWO

Two levers need to be adjusted at same time and same angle on different direction.