EQMod: Connection via "Ethernet" (Wifi)

dark energy

Hi,

in the ASIair app I have to enter the connection parameters

(Ethernet, IP address, port number, UDP) each time the

ASIair is powered on.

I am using the ASIair with a Skywatcher AZ-EQ6 and a Skywatcher

Wifi Module. First I turn on the mount and make a two star alignment,

then I enter the connection Data and everything is fine.

When the ASIair is turned off it looses all the connection

data and I have to re-enter it again the next time I use it.

Is there a way to make the ASIair keep the data?

Thank you

Markus

Tech@ZWO

Hi Markus:

Once you connected successfully with the mount via “Ethernet”(Wifi),the parameter will be saved by Asiair,including the ip,the port and the tcp&udp mode.

When you re-powered your mount,you need to connect it again, just like when you start the car, it still keeps the previous setting，such as the “race mode”

dark energy

Hi,

I don't know, if I understand you.

You say, that the IP address and the other data should be saved after it was entered and the mount was connected, right?

Unfortunately that isn't the case: All the parameters are gone after powering the ASIair off and on and I have to ree-enter everything.

That's no big problem but could be better … ;-)