Problem with OAG ZWO and guiding with ASIAIR

Nebula42

Hi there
I got problem, I used askar400 + filter drawer zwo + oag zwo + 482MC managed with Asiair plus.
Guiding with 120 mini
All on the AVX mount
The stars were visible and focus was good in the main camera and the guiding camera.
Also on the settings I put 400 mm for main camera and guide camera.

I did the PA
First try
Direction M31
Calibrating and start guiding
RMS : 300

Too much
I stopped it
Did another PA
Direction M31 again
Guiding and RMS : 3

I stopped it
Did another PA
Direction M31
I started the guiding but this time, the asiair stated the calibration without stopping, easily 5 minutes and I stopped the calibration, clear, and started another calibration, again non stop.

I was wondering what's the issue with this.
Thank you for your help in advance

Tech@ZWO

Nebula42 There are many factors that may affect this, usually, we recommend calibrating within 30 degrees of the celestial equator.
You can also check these:
1 The balance of your mount
2 Star choosing of the guiding calibration
3 Calibration step -> too small value may cause long time calibration.

Please check the angle of the calibration lines, the closer to the right Angle, the better.

Nebula42

Tech@ZWO

Hi
Thank you for your help and time

Nebula42

Tech@ZWO
Hi
The problem was the settings on aisiair
It was 2000 ms everywhere and needed to be modified between 250 and 600 ms