HELP! Big difficulties in the Autoguide parameters

Lorix

Good morning everyone, I'm writing here because I've been looking for answers to my big problem for a long time but I haven't been able to find anything.
I can't practically use the autoguide since the values (especially DEC) are always very high.

My setup is as follows:
AA+
EqMod Mont (EQ5)
Main 715mm (TS102ED) - ASI 533MC Pro
Guide 240mm - ASI 120MM Mini

Gain 48
Cal Step 2000ms
Max Dec dur 1000ms
Max RA dur 1000ms

Stability 2", Settle 5s, No Bin2

RA Aggr 70%
Dec Aggr 70%
Dec North
Exp 2"

I tried varying the aggressiveness and exposure values but nothing substantial.

Thank you very much to anyone who can help me!
It's really frustrating not being able to use the autoguide even though you have all the tools.

Lorix

PMTeam@ZWO

Lorix Hi, it's recommended to initially set the RA/DEC duration to 1000/1000, then adjust DEC Auto and set the RA/DEC Aggr to 50%. After starting the guide, you can gradually fine-tune the settings based on the guide curve.

Lorix

PMTeam@ZWO
thank you very much for the quick reply, so my parameters: cal 2000ms and max Ra dec at 1000ms are fine and I should bring the aggressiveness to 50% for both with Dec Auto?

After how should I proceed, obviously in broad terms, to understand towards which modification I should implement?

Thank you!!!!

PMTeam@ZWO

Lorix Yes, we recommend adjusting DEC Auto and starting with 50% as a baseline for aggression, then increasing or decreasing by 10% over a period to see if it has an effect. We can't provide a more specific analysis at this time, as further judgment would require access to your logs.

You can start by trying the suggested settings. If the issue persists, please upload the device log by going to the "About" page and clicking "Bug Report". Thank you.

Lorix

Thank you so much, i will try!!