Unknown Subs

BigJRocksIt

I recently captured some subs of M51 that were labeled as “unknown subs” and I’m unable to stack them with the other M51 subs. Is there a way to rename or move these unknown subs to the correct folder?

Daemon42

BigJRocksIt Get your Seestar setup on the same wifi network as your PC.
Then on your PC hit windows - R and type \seestar
It should open up a connection to the drive shared by the seestar unit.
Go into \seestar\EMMC Images\MyWorks
Create a new folder with a _sub extension.. ala..
mytarget1_sub then copy (or move) all the images from the two or more different folders you want to stack.
It only cares about the .fit files but easier to just copy all of em.
Now when you go to stack images on the Seestar image, it'll show mytarget_sub and you can select at will.

If you really trust what you're doing you can just copy stuff from one existing sub folder into the other.

starnet59

This is a nifty trick, I learn something new every day. However, I am not sure what "on your PC hit windows - R and type \seestar" is supposed to do, on my Windows 11 I get a "Windows cannot find '\seestar'. Make sure you typed the name correctly, and the try again." error message. I was never able to access the data on the S50 over WiFi, and I did really try. I can ping the S50's IP address, but when I try to use Windows Explorer to access it, it asks me for a user name and password and I was never able to go past that point.

I can only access the S50 over USB, and even that is flaky, sometimes it fails but if I shut down the S50 and then turn it on again it works.