Can't connect ASIAIR Plus 256GB to CEM60

tomzo

Greetings,

I can't seem to get the ASIAIR to talk to my CEM60. I used an FTDI USB to serial cable and connected it to the D9 to phone jack cable that came with the CEM60 and tried in both the RS232 and handset ports - no luck. The baud rate is set to 9600 per the ASIAIR instructions, though I tried the faster rates with the same results.

Thinking that there may be an issue with the cable pinouts (both cables had the male connection screws) I bought a null modem adapter as a crossover but that too failed.

Does anybody know what I am missing here?

Thanks

Tom

tomzo

I am bumping this post again. I have tried everything I can think of to get this working. My CEM60 firmware is all up to date and I even bought an ioptron StarFi wifi connector to see if the ASIAIR could connect over wifi. I can control the mount from my PC using iOptron Commander over wifi just fine, but the ASIAIR still won't connect.

PMTeam@ZWO

tomzo Hello, when did you purchase your CEM60? What is the firmware version of your CEM60?

PMTeam@ZWO

tomzo Hello. We noticed that you are using the latest firmware of CEM60. We checked the relevant logs and found that we cannot obtain the RA and DEC of CEM60 through the interface, so the connection is disconnected. We recommend that you contact the manufacturer of CEM60 to find out whether the driver connection method needs to be changed due to the firmware upgrade. Thank you.